TM 9-2350-256-20-2
0275 00
3.
Install and block roadwheel arm (see WP 0276 00).
4.
Install torsion bar (6) using adapter and puller as follows: Coat serration (12) on both ends of torsion bar with GAA grease
(see WP 0097 00). Screw adapter into tapped holes in end of torsion bar. Screw puller into tapped hole in adapter. Hold
torsion bar so that V-notch (13) cut into chamfer on outer end is at top. Slide torsion bar in and rotate until blank serration
(14) in inner end of torsion bar (opposite V-notch) aligns with blank serration in torsion bar anchor (10). Push torsion bar in
far enough to engage torsion bar anchor. Turn roadwheel arm (3) in direction of arrow on torsion bar until blank serration
(adjacent to V-groove) in outer end of torsion bar aligns with blank serration in arm (opposite V-groove in arm). Push bar
in as far as it will go. Pack cavity in roadwheel arm with GAA grease.
5.
Install torsion bar end plug (4) and gasket (5) using wrench plug.
6.
Install screw (1) and lockwasher (2). Torque screw to 75100 lb-ft (102136 Nm).
NOTE
Follow-on maintenance: Connect shock absorber (see WP 0285 00); Connect idler link (see WP 0281
END OF WORK PACKAGE
0275 00-3/4 blank
