TM 9-2350-256-20-2
0401 00
NOTE
Repeat steps 3 through 6 for each cylinder control valve.
3.
Break safety seal (6) and pull safety pin (7).
4.
Remove cover assembly (8) by removing three screws (9) and three lockwashers (10).
5.
Loosen two screws (11) and disconnect cable (12).
6.
Remove cable pulley assembly (13) from cylinder control valve housing (14) to remove cable (12) from housing.
Inspection-Acceptance and Rejection Criteria
1.
Inspect system components for wear, corrosion, and damage. If necessary, remove defective parts and replace.
2.
Clean and dry all items before installation.
Installation
NOTE
Repeat steps 1 through 5 for each cylinder control valve.
1.
Wind cable (12) around sheave of cable pulley assembly (13) and secure by tightening two screws (11).
0401 00-2
