TM 9-2350-256-20-2
UNIT MAINTENANCE
RECOVERY VEHICLE, FULL TRACKED: MEDIUM, M88A1
NSN 2350-00-122-6826, EIC AQA
DECAL MARKINGS REPLACEMENT
REMOVAL, INSTALLATION
INITIAL SETUP:
Materials/Parts
References
Compound, cleaning (item 9, WP 0489 00)
TM 9-2350-256-10
Removal
WARNING
Solvents can burn easily, give off harmful vapors, and are harmful to skin and clothing. To avoid injury
or death, keep away from open flame and use in a well-ventilated area. If solvent gets on skin or clothing,
wash immediately with soap and water.
NOTE
Many of the markings within the vehicle are decals. If these decals become damaged and are no longer
legible, they should be replaced. TM 9-2350-256-10 illustrates the various decals and their locations.
1.
Before removing a damaged decal, note its position. Then remove it by scraping, and cleaning scraped area with cleaning
compound. Apply new decal over scraped area.
Installation
1.
Spot paint area if required.
2.
Remove carrier sheet (backing sheet) from back of new decal by dipping decal in water for approximately 20 seconds.
3.
Place new decal in same position as old decal and roll down firmly.
END OF WORK PACKAGE
0482 00-1/2 blank
