T M 9 - 2 3 5 0 - 2 5 6 - 2 0 APPENDIX J: LUBRlCATlON INSTRUCTlONSJ-5 LUBRICATION INSTRUCTIONS-Continuedc. SERVICE FROM ENGINE COMPARTMENT-Continued10 Accelerator linkage bell crank and pillow block. Each time engine is removed, lubricate with GAA throughbell crank fitting (19) and two pillow block fittings (20).11Auxiliary Power Unit (APU) engine oil filter.APL! engine is hot after operation. Use caution when reaching into APU compartment.NOTEOil filter should be changed each time the APU engine crankcase oil is changed. Filter should bereplaced more frequently when operating in extremely dusty environments.a.Open right front engine grille door (21).b.Remove oil filter (22) with a wrench, and discard filter.c.Lightly lubricate gasket (23) of replacement filter and tighten it until gasket contacts base; then tightenfilter (32) an additional one-half turn.NOTEDo not overtighten filter.d.Start APC engine (refer to TM 9-2350-256-10) and check for oil leaks around filter gasket (23). Tightenfilter (23) as necessary if leakage occurs.e.Close right front engine grille door (21).J-32Change 1
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business