REPLACE/REPAIR/SERVICE PRIMARY FUEL FILTER

SECTION II: PRIMARY, FUEL/WATER SEPARATOR, AND MANIFOLD HEATER FUEL FILTERS AND RELATED PARTS

TM-9-2350-256-20 Carrier Cargo Tracked 6-Ton M548A1 (2350-01-096-9356) M548A3 2350-01-369-6081 Manual
Page Navigation
496

CHAPTER 4: MAINTENANCE OF MAIN ENGINE FUEL, AIR INTAKE, TM 9-2350-256-20 AND EXHAUST SYSTEMS 4-14 REPLACE/REPAIR/SERVICE PRIMARY FUEL FILTER-Continued 3 Loosen retaining screw (3) and remove fuel filter head (4). Remove and discard filter head gasket (5). 4 Remove fuel filter element (6) from filter body (7). Discard fuel filter element. WARNING Dry-cleaning solvent used to clean parts is potentially dangerous to personnel and property. Do not use near open flame or excessive heat. Flashpoint of solvent is 1380F (590C). 5 Clean inside of filter body (7) with dry-cleaning solvent and stiff brush. Scrape off sludge or gum, if necessary. 6 Attach constant bleed line (2) and install new fuel filter element (6). 7 Install fuel filter head (4) using new filter head gasket (5), and tighten retaining screw (3). 8 Bleed air from primary fuel filter. Activate electric fuel pump until fuel runs from bleeder valve (1), then tighten bleeder valve. b. REMOVAL WARNING Do not smoke or use open flame when working on fuel system: explosion may occur, causing severe injury or death. 4— 32

Privacy Statement
Press Release
Contact