Emergency Flasher Circuit

Figure 2-14. Batteries to master relay, main engine and APU, voltage regulators, main engine disconnect and slave receptacle cable assemblyremoval and installation

Figure 2-15. Powerplant wiring harnessremoual and installation. (Sheet 1 of 2).

TM-9-2350-256-34-1 Recovery Vehicle Full-Tracked: Medium M88A1 (NSN 2350-00-122-6826) Manual
Page Navigation
46

TM 9-2350-256-34-1 Legend for fig. 2-14: Deleted g. Emergency Flasher Circuit (No. 325) Wiring Harness. (1) Removal (a) Disconnect the harness from the left front red flasher indicator lamp. Remove the shell, washer, and ferrule from the cable (fig. 3-20) so that cable can slide through narrow opening. (b) Remove interfering components as required for access at various points. Disconnect cable connectors, loosen. or remove any cable clamps and remove wiring harness. (2) Installation (a) Replace missing or defective chassis grommets. (b) Install wiring harness in reverse order of removal, threading the cable through to the front red flasher indicator lamp without the connector installed. (c) Install the ferrule, washer, and shell as shown in figure 3-20 and connect to the indicator lamp. h. Powerplant Wiring Harness. (1) Removal Prior to removal of the powerplant wiring harness, remove engine deck assembly (TM 9- 2350-256-20). Remove interfering components as required for access. Remove powerplant wiring harness as shown in CHANGE 7 2-31

Privacy Statement
Press Release
Contact