TM 9--2350--292--10
0101 00--63
PREVENTIVE MAINTENANCE CHECKS AND SERVICES INCLUDING
LUBRICATION INSTRUCTIONS -- CONTINUED
0101 00
TABLE 6 LUBRICATION INSTRUCTIONS
SCOPE
This appendix lists and prescribes cleaning and lubrication procedures as to locations, intervals and proper materi-
als for this vehicle.
GENERAL
1. General. Any special lubricating instructions required for special mechanisms or parts are contained in the
pertinent section.
2. Service intervals. Service intervals specified in this Table for normal operations and where moderate
temperature, humidity and atmospheric conditions prevail. Report unsatisfactory performance of prescribed fuels,
lubricants, or preserving materials, using DA Form 2407, Maintenance Request.
This Table is divided into lubrication intervals. When performing lubrication, refer to daily, monthly, and quarterly
intervals as appropriate. Intervals (on--condition or hard time) and the related man--hour times are based on nor-
mal operation. The man--hour time specified is the time you need to do all the services prescribed for a particular
interval. On--Condition (OC) oil sample intervals shall be applied unless changed by the Army Oil Analysis Pro-
gram (AOAP) laboratory. Change the hard time interval if your lubricants are contaminated or if you are operating
the equipment under adverse operating conditions, including longer than usual operating hours. The hard time in-
terval may be extended during periods of low activity. If extended, adequate preservation precautions must be tak-
en. Hard time intervals will be applied in the event AOAP laboratory support is not available.
Engine oil/transmission oil/hydraulic fluids must be sampled as prescribed by DA PAM 738--750.
Lubrication point pictures with dash lines (-- -- -- -- --) means there are lubrication points on both sides of the vehicle.
WARNING
All PMCS and scheduled maintenance as required by operation and maintenance
manuals must be performed before operating vehicle. Failure to do this may result
in personnel injury/death and/or system damage due to system failure or degraded
system operation.
