HYDRAULIC RESERVOIR OIL LEVEL CHECK (C)

TABLE 6 LUBRICATION INSTRUCTIONS (cont) - TM-9-2350-292-10_357

TM-9-2350-292-10 Carrier Ammunition Tracked M992A1(NSN 2360-01-362-3021) EIC:AE6 Manual
Page Navigation
336

TM 9--2350--292--10 0101 00--84 PREVENTIVE MAINTENANCE CHECKS AND SERVICES INCLUDING LUBRICATION INSTRUCTIONS -- CONTINUED 0101 00 TABLE 6 LUBRICATION INSTRUCTIONS -- CONTINUED 15. HYDRAULIC RESERVOIR OIL LEVEL CHECK (C) WARNING CAUTION Do not over fill hydraulic reservoir with boom in down position. when boom is raised, hydraulic fluid will overflow out of the bayonet gage neck. Overfil- ling may cause damage to equipment. Park vehicle on a level surface. Remove two screws, two flat washers, and subfloor access plate. Remove bayonet gage, wipe clean and insert. Remove bayonet gage and verify oil is above the DANGER mark. If required, remove filler cap and add proper grade oil (WP 0101 00--65) to bring oil level above DANGER mark. Insert bayonet gage. Start main engine (WP 0012 00) and operate hydraulic system until hydraulic oil is at operating temperature. Shut off main engine (WP 0019 00). Remove bayonet gage and verify that oil level on HOT side of bayonet gage reaches the lower FULL mark with the boom down or the upper FULL mark with the boom up. If required, remove filler cap and add additional oil. Install filler cap and bayonet gage. Install subfloor access plate. BOOM UP FULL HOT BOOM DOWN DANGER SUBFLOOR ACCESS PLATE BAYONET GAUGE FILLER CAP

Privacy Statement
Press Release
Contact