TM 9--2350--292--20--1
0235 00--4
ENGINE COOLING FANS AND HOUSINGS REPLACEMENT -- CONTINUED
0235 00
Installation--Continued
3. Install radiator fan shroud (19) to mounting bracket (23) with two screws (22), two flat washers (21) and two nuts
(20). Do not tighten screws and nuts.
4. Install two screws (16), two flat washers (17) and two new lockwashers (18) in radiator fan shroud (19). Do not
tighten screws.
5. Install engine cooling adapter (12) on axial fan (13) with 16 screws (10), 16 flat washers (11),
16 slotted nuts (9) and 16 new cotter pins (8).
6. Install axial fan assembly (7) on engine with flat washer (6) and slotted nut (5).
7. Torque nut (5) to 117--121 lb--ft. (158.6--164 N•m) and install new cotter pin (4).
8. Check clearance between end of axial fan (13) blade--end and rim of radiator fan shroud (19) housing with fan
rotor gauge at four equal positions. If clearance is not established, shift radiator fan shroud housing (19) as nec-
essary until clearance is obtained. Tighten screws (16 and 22) and nuts (20).
9. Install two access plates (15) on radiator fan shroud (19) with 10 new assembled--washer screws (14).
Figure 42
14
15
19
20
21
4
5
6
12
13
11
10
8
9
7
15
22
23
16
17
18
14
