TM 9--2350--292--20--1
0313 00--2
WIRING HARNESS 3W801 REPLACEMENT -- CONTINUED
0313 00
Removal--Continued
2. Remove nut (4), lockwasher (5), lockwasher (6) and two wiring harness leads E and V (7 and 8) from positive bus
bar (9). Discard lockwashers.
3. Remove two screws (10), two lockwashers (11), two flat washers (12) and two wiring harness leads X and Y (13
and 14) from shunt (15). Discard lockwashers.
4. Remove screw (16), lockwasher (17) and wiring harness lead F (18) from negative bus bar (19). Discard lock-
washer.
5. Remove nut (20), lockwasher (21) and wiring harness lead W (22) from negative bus bar (19). Discard lockwasher.
6. Remove 10 screws (23), 10 lockwashers (24) and 10 clamps (25) as necessary. Discard lockwashers.
7. Disconnect wiring harness 3W801 connector P1 at bulkhead disconnect (26) and wiring harness 3W801 connec-
tor P2 at engine disconnect bracket (27). Remove wiring harness from engine compartment.
8. Inspect parts for damage and replace as required.
Figure 125
19
18
17
16
22
21
20
6
8
7
5
4
9
25
24
23
26
27
10
12
11
14
15
10
11
12
13
