TM 9--2350--292--20--10173 00--2SYSTEM WARNING LIGHT DOES NOT GO OUT AFTER ENGINE IS STARTED-- CONTINUED0173 00CDid warning light remain lit after engine was started?CONTINUED FROM STEP BnoyesCONTINUED ON NEXT PAGE1. Reconnect harness 3W202 connector to enginehigh oil temperature switch.2. Disconnect harness 3W202 connector fromtransmission high oil temperature switch.3. Turn MASTER switch ON and start engine(TM 9--2350--292--10). Watch warning light.4. Shut down engine and turn MASTER switchOFF (TM 9--2350--292--10).Replace transmissionhigh oil temperatureswitch (WP 0349 00).Verify fault is corrected.DDid warning light remain lit after engine was started?noyes1. Reconnect harness 3W202 connector totransmission high oil temperature switch.2. Open air intake grilles above batterycompartment (TM 9--2350--292--10).3. Disconnect harness 3W143 P2 from bulkheaddisconnect bracket.4. Turn MASTER switch ON and start engine(TM 9--2350--292--10). Watch warning light.5. Turn MASTER switch OFF(TM 9--2350--292--10).EDid warning light remain lit after engine was started?1. Reconnect harness 3W143 P2 to bulkheaddisconnect bracket.2. Disconnect harness 3W143 P1 from enginedisconnect bracket.3. Turn MASTER switch ON and start engine(TM 9--2350--292--10). Watch warning light.4. Turn MASTER switch OFF(TM 9--2350--292--10).Repair (WP 0290 00) orreplace (WP 0316 00)harness 4W103. Verifyfault is corrected.
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business