TM 9--2350--292--20--1
0176 00--3
SYSTEM WARNING INDICATOR WILL NOT COME ON WHEN ACTIVATING
WINCH TEST SWITCH -- CONTINUED.
0176 00
F
Is continuity present?
CONTINUED FROM STEP E
no
yes
CONTINUED ON NEXT PAGE
Place one multimeter lead on terminal board T14
terminal A and other multimeter lead on terminal
board T14 terminal B. Check for continuity.
Replace terminal board
T14 (WP 0244 00).
Verify fault is corrected.
G
Is 24 V dc present?
no
yes
1. If not disconnected, disconnect harness
4W618 connector P2 from harness 4W617
connector J1 (WP 0331 00).
2. Turn vehicle MASTER switch ON
(TM 9--2350--292--10).
3. Place red multimeter lead on harness 4W618
connector P2 pin H and black multimeter
lead to ground. Check for voltage.
4. Turn vehicle MASTER switch OFF
(TM 9--2350--292--10).
Repair (WP 0290 00) or replace
(WP 0330 00) harness 4W617.
Verify fault is corrected.
CONTINUED
FROM STEP A
H
Is 24 V dc present?
no
yes
1. If not disconnected, disconnect harness 4W618
connector P1 from PTO/accessory panel (WP
0331 00).
2. Turn vehicle MASTER switch ON
(TM 9--2350--292--10).
3. Place red multimeter lead on PTO/accessory
panel connector J2 pin 18 and black multimeter
lead to ground. Check for voltage.
4. Turn vehicle MASTER switch OFF
(TM 9--2350--292--10).
Repair (WP 0290 00) or
replace (WP 0331 00)
harness 4W618. Verify
fault is corrected.
