TM 9--2350--292--20--2
0667 00--27
DEEP WATER FORDING KIT -- CONTINUED
0667 00
Installation--Continued
ARMAMENT PROTECTION
Cover the .50--caliber machine gun with its protective cover (TM 9--2350--292--10).
SEALING INSPECTION
1. When time and facilities permit, the engine compartment should be flooded with water. At this time, a thorough
inspection should be made at the bulkhead power takeoff drive shaft cover to discover any leaks. The engine
should be operated to detect any malfunctions as a result of water leakage.
NOTE
To prevent buildup of sand in engine compartment during
fording operation, removal of access covers under engine
compartment is necessary.
2. Remove and stow two access covers, gaskets and mounting hardware from hull under engine compartment (WP
0434 00).
3. Pour a bucket of water around base of each engine air inlet. Look through air selector valve for evidence of leaks.
If leaks are found, reseal engine air inlet.
INSTALLATION OF SUBFLOOR PLATES, ENGINE DECK GRILLES AND ENGINE DECK DOORS
1. Install any subfloor plates (WP 0454 00) previously removed and not reinstalled.
2. Install any engine deck grilles (TM 9--2350--292--10) previously removed and not reinstalled.
3. Install or close any engine deck doors (TM 9--2350--292--10) previously removed or opened and not reinstalled or
closed.
