TM 9--2350--292--20--20566 00--2FUEL TRANSFER PUMP MOTOR AND STAYLINE CYLINDER HYDRAULICLINES AND FITTINGS REPLACEMENT -- CONTINUED0566 00Removal--ContinuedWARNINGHydraulic system pressure is rated 4450 psi. Do nottorque hydraulic fittings or perform removal procedureswhen hydraulic system is pressurized. Discharging sys-tem pressure before performing any maintenance proce-dures will prevent injury to personnel.Eye protection will be worn when performing mainte-nance procedures on all hydraulic components to preventinjury to personnel.CAUTIONCap all hydraulic lines and plug all hydraulic ports to pre-vent contamination. Failure to comply may result in dam-age to hydraulic system.All serviceable components must be placed in plasticbags to prevent contamination of hydraulic system duringinstallation.NOTEAll hydraulic lines and components must be tagged be-fore removal for identification during installation.Place rags under hydraulic connections to catch any hy-draulic fluid that spills during maintenance. Dispose offluid--soaked rags in accordance with standard operatingprocedure.1. Remove hose assemblies, lines and fittings in accordance with the following legend and illustration.2. Inspect parts for damage and replace as required.Installation1. Apply sealing compound to all male pipe threads before installation of the component.2. Install hose assemblies, lines and fittings in accordance with the following legend and illustration.NOTEFOLLOW--ON MAINTENANCE:Install hose clamps, if removed (WP 0583 00)Install subfloor plate #32 (WP 0454 00)Install APU assembly (WP 0586 00 or WP 0587 00)Install stayline cylinder access covers (WP 0276 00)Install engine deck assembly (WP 0417 00)Install engine deck grilles (TM 9--2350--292--10)Close engine deck grille doors(TM 9--2350--292--10)
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business