TM 9--2350--292--10
0110 00--1
TRACK INSTALLATION
0110 00
THIS WORK PACKAGE COVERS:
Installation
INITIAL SETUP:
Tools and Special Tools
Track binder (item 7, Table 2, WP 0128 00)
Adjustable wrench (item 40, Table 2, WP 0128 00)
Tankers bar (item 5, Table 2, WP 0128 00
Track connecting fixtures (2) (item 14, Table 2, WP
0128 00)
Sledgehammer (item 32, Table 2, WP 0128 00)
Materials/Parts
Rope, fiberous (item 29, Table 2, WP 0128 00)
Personnel Required
Three
References
WP 0128 00
WP 0103 00
WP 0012 00
WP 0104 00
WP 0102 00
WP 0014 00
WP 0019 00
WARNING
1. Lay out new or thrown track (1) in front of vehicle and in line with the roadwheels (2) with the V pattern of the
track pads pointing to the rear.
NOTE
If installing new track, temporarily attach new track to old track with two end connec-
tors but without wedges or bolts.
2. Place heavy metal plate or sturdy plank (3) on track link near vehicle to form a ramp. If plate or plank are not
available, dig a trough under the first few track links so that the upper surface of the links are level with or slightly
below ground surface.
3. Start main engine (WP 0012 00).
4. Shift transmission selector to first gear (1st) (WP 0014 00) and release brakes.
5. Turn steering wheel in the direction of the track being installed.
6. Using ground guides move vehicle forward onto track (1) until center of first roadwheel (2) is resting on top of the
16th track link from front of track.
7. Apply brakes and shift transmission selector to park (P) (WP 0014 00).
8. Open armor skirt plates #1, #3, #5, and #7 (WP 0102 00).
1
2
3
1
2
16 LINKS
SIDE ARMOR SKIRT PANELS REMOVED FOR CLARITY