TM 9--2350--292--20--2
0407 00--1
SHIFTING CONTROL LINKAGE (ENGINE COMPARTMENT) REPAIR
0407 00
THIS WORK PACKAGE COVERS:
Removal, Disassembly, Assembly, Installation
INITIAL SETUP:
Tools and Special Tools
General mechanics tool kit (item 1, WP 0717 00)
Retaining ring pliers set (item 15, WP 0717 00)
Materials/Parts
Lockwashers (10) (item 2, WP 0718 00)
Lockwasher (item 27, WP 0718 00)
Lockwasher (item 9, WP 0718 00)
Lockwasher (item 12, WP 0718 00)
Retaining rings (2) (item 44, WP 0718 00)
Adhesive (item 15, WP 0716 00)
Welding electrodes (AR) (item 9, WP 0716 00)
Dry--cleaning solvent (item 1, WP 0716 00)
Equipment Conditions
Vehicle parked on level ground with tracks
blocked and parking brake set
(TM 9--2350--292--10)
Subfloor plates #19 and #24 removed
(WP 0454 00)
Battery trays removed (WP 0288 00)
Left side air cleaner assembly removed
(WP 0208 00)
Engine deck assembly removed (WP 0417 00)
Powerpack removed (WP 0188 00)
Lubrication tubes disconnected and fittings
removed from bell crank (WP 0409 00)
References
TM 9--2350--292--10
NOTE
This task replaces the portion of the steering control
linkage found in the engine compartment Perform only
those steps necessary to replace the defective parts.
Removal of the left side floor plates, left side air cleaner
assembly and battery trays are required only for the
replacement of the thru bulkhead linkage.
Removal of the battery trays are required only for
replacement of the near bulkhead linkage.
Removal of powerpack is required for replacement of bell
crank on mounting bracket near battery compartment.
Removal of powerpack is required only for replacement of
bell crank and linkage on mounting bracket near
transmission.
All levers, brackets and bell cranks are provided with a
1/8--in. alignment hole to aid in the proper alignment
during Installatioln Levers, brackets or bell cranks not
being removed must be pinned before disconnecting
components.