TM 1-1680-320-13&P
0015 00
3. Assemble upper carrier assembly (3), disc (14) and cable hook boot (13).
4. Assemble lower carrier assembly (2) by installing lower carrier half (4), bearing (5), and split retainer
assembly (6) on cable hook assembly (1).
5. Secure cable hook assembly (1) with split retainer assembly (6) by sliding bearing (5) upward on cable hook
assembly (1).
6. Pull approximately 18 inches of cable through cable hook boot assembly and install split retainer assembly
(10) on cable, secure with retainer packing (9), and pull cable until split retainer assembly (10) seat into upper
carrier assembly (12).
NOTE
The flat side of cap (7) must be installed against split retainer assembly (6).
7. Install packing (8) on cap (7) and install into upper carrier assembly (12).
8. Assemble upper carrier assembly (3) and lower carrier assembly (2) with cable hook assembly (1) by hand
tightening lower carrier assembly (2) to align carrier assembly slots.
9. Install carrier lockspring (11).
10. Connect power (28 vdc) to hoist.
11. Position control pendant CABLE UP/DOWN switch to UP and retract cable until cable hook assembly (1) is
seated.
12. Rotate cable hook assembly (1) 360 degrees to ensure proper operation.
13. Conduct performance test in accordance with WP 0011 00.
0015 00-6
