TM 1-1680-320-13&P
0015 00
NOTE
Carrier assembly and bearing retainer (11 and 9), are a matched set. Replace
only as an assembly.
1. Assemble cable hook (1) by installing lower carrier (3), bearing (4), retainer nut (6).
2. Tighten bearing retainer nut (6) to align it with cable hook assembly (1) hole and install pin (5).
3. Install cable through upper striker disc (13), cable hook boot (12), and upper carrier (11).
NOTE
Cable retainers are a matched set. Replace only as an assembly.
4. Install split retainer assembly (9) on cable end by securing with packing (10).
5. Grasp cable at top of upper striker disc (13), and pull until split retainer assembly (9) seats into recess carrier
retainer (11).
6. Lubricate packing (8) and install on cap (7).
7. Install cap (7) into carrier retainer (11) with flat side against recessed upper carrier (11).
8. Assemble cable hook (1) by screwing lower carrier (3) to upper carrier (11).
9. Install carrier assembly lockspring (2).
10. Connect power (28 vdc) to hoist.
11. Position control pendant CABLE UP/DOWN switch to UP and retract cable until cable hook assembly is
seated.
12. Rotate cable hook assembly 360 degrees to ensure proper operation.
13. Conduct performance test in accordance with WP 0011 00.
End of Work Package
