TM 1-1680-320-13&P
HIGH PERFORMANCE RESCUE HOIST ASSEMBLY
CABLE - REMOVAL
INITIAL SETUP
Personnel Required: 1
References:
UH-1: 15N, Helicopter Repairer
AVUM/AVIM Manual for General Aircraft
UH-60: 15T, Helicopter Repairer
Maintenance TM 1-1500-204-23 series
Hoist Certified: 91W, Flight Medic
Aircraft Electrical and Electronic Manual
TM 1-1500-323-24 series
Parts/Materials:
Cleaning and Corrosion Control
Insulation Sleeving
TM 1-1500-344-23 series
Petrolatum (WP 0047 00, Table 1, Item 27)
Screw, AN3H26A
Tools and Special Tools:
Tool Set, Aviation Unit Maintenance
NSN 4920-00-567-0476
Tool Kit, Aircraft Mechanic
NSN 5180-00-323-4692
Cable Spool, 42277-730 or equivalent
Ground Power Unit (GPU)
Hex Wrench (WP 0037 00)
WARNINGS
The hoist cable cutter contains an explosive cartridge. Use extreme caution
when handling to prevent injury to personnel. Spark or static producing
clothing is prohibited. Anytime cable cutter harness is disconnected, install
shorting device or piece of aluminum foil between cartridge pins and install
shipping cap to prevent accidental firing.
To avoid injury to personnel from broken wire strands, leather gloves must be
worn at all times when handling cable assembly.
1. Remove cable hook assembly in accordance with WP 0015 00.
2. Disconnect cable cutter electrical connector.
