TM 1-1680-320-13&P
0024 00
NOTE
Cable assembly shall not contact inside surface of cable cutter.
5. Observe hoist cable by sighting along cable assembly from sheave assembly, through cable cutter and to
winch assembly.
6. If cable does not contact cable cutter assembly, no adjustment necessary, proceed to step 13. If cable does
contact cable cutter assembly, continue with step 7.
NOTE
Do not remove chain.
7. Remove chain guard (14) by removing screws (15) and washers (16).
8. Remove lockwire from screws (10) and discard.
9. Remove screws (10) and washers (11).
10. Rotate stationary gear (13) to translate drum assembly and align cable.
11. Install washers (11), screws (10), torque screws 24-27 in. lbs., and secure using lockwire.
12. Install chain guard (14) by installing screws (15), washers (16), and torque screws 24-27 in. lbs.
0024 00-5
