TM 9-2350-238-10
Table 3-1. TROUBLESHOOTING–CONTINUED
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
CAB, BOOM, AND WINCHES–CONTINUED
31. CAB WILL NOT TRAVERSE.
Step 1.
Check to see if traversing pressure selector valve (1 ) is in open position.
Push pressure selector valve in to close valve. Refer to page 2-90.
Step 2. Check to see if linkage to traversing foot pedal (2) is disconnected.
If disconnected, install linkage on foot pedal.
If cab still will not traverse, notify unit maintenance personnel.
32. BOOM WILL NOT RAISE OR LOWER.
Step 1.
Check to see if single boom block is released from hull.
Operate boom winch to pay out cable and disconnect single boom
block from front of vehicle.
3 - 24
