TM 9-2350-238-34-1
2 - 1 7 . T Y P I C A L M A L E - T Y P E P L U G
D I S A S S E M B L Y
1
2
3
4
5
6
CONNECTOR.
Unscrew nut (1) from shell assembly (2) and
slide back on cable (3).
Slide grommet (4) back on cable leads (5).
Slide coupling (6) off shell assembly (2).
Drive pin contacts (7) out through rear of
insert (8) with pin extractor.
Push insert (8) out through rear of shell
a s s e m b l y ( 2 ) .
Unsolder cable leads (5) from pin contacts
( 7 ).
R E A S S E M B L Y
1
2
3
4
5
6
7
8
9
Strip cable of insulation equal to depth of
solder wells of pin contacts (1).
Slide nut (2) over cable (3).
Slide grommet (4) over cable leads (5).
Insert cable leads (5) into solder wells of pin
contacts (1) and solder .
Push insert (6) into shell assembly (7) from
rear until seated. Groove (8) in insert (6)
must be aligned with guide in shell assembly
(7) to ensure proper fit.
Push pin contacts (1) into insert (6) from rear
u n t i l s e a t e d.
Slide coupling (9) onto shell assembly (7).
P u s h g r o m m e t ( 4 ) d o w n c a b l e l e a d s ( 5 ) a nd
over solder wells of pin contacts (1).
Screw nut (2) onto shell assembly (7).
2 - 26
