TM 9-2350-238-34-1
R E A S S E M B L Y
1
2
3
4
5
6
N O T E
E n s u r e b r u s h w i r e p a s s e s t h r o u gh
b o t t o m o f c o m p r e s s i o n s p r i n g.
Install eight new brushes (1) in eight new
c o m p r e s s i o n s p r i n g s ( 2 ).
Install eight brushes (1) and eight compres-
sion springs (2) in outer contact set holder
(3) with brush wire passing through hole in
bottom of outer contact set holder.
Press eight brushes (1) up and down in
h o l e s t o e n s u r e f r e e m o v e m e n t.
Pull slack out of eight brush wires without
c o m p r e s s i n g a n y o f t h e e i g h t c o m p r e s s i on
s p r i n g s ( 2 ).
Solder eight brush wires to outer contact set
h o l d e r ( 3 ) p e r T B S I G - 2 2 2.
Clip off excess wire.
E n s u r e s o l d e r a n d w i re
do not rise above groove in outer contact set
h o l d e r ( 3 ).
2 - 8 7
