ADJUSTMENT (cont) - TM-9-2350-238-34-2

ADJUSTMENT (cont) - TM-9-2350-238-34-2_181

ADJUSTMENT (cont) - TM-9-2350-238-34-2_183

TM-9-2350-238-34-2 Recovery Vehicle Full-Tracked: Light Armored M578 (2350-00-439-6242) Manual
Page Navigation
173

TM 9-2350-238-34-2 10 11 12 13 14 15 16 Do not allow pressure to go over 500 psi (3448 kPa). Failure to fol- low instructions may result in damage to equipment. Loosen nut (7). Watching oil pressure tester, push BOOM cylinder control handle (8) slowly to LOWER. If necessary, turn screw (9) counterclockwise to decrease pressure. Needle valve (10) can be adjusted by hand to provide a steady oil pressure tester reading. Adjust pressure for pressure relief valve (11) to between 180 and 220 psi (1241 and 1517kPa) by turning screw (9) counterclockwise to decrease pressure or clockwise to increase pressure. When correct pressure adjustment is ob- tained, tighten nut (7). If correct pressure adjustment cannot be obtained, replace pressure relief valve. Refer to page 2-163. Slowly lower boom to stow position. Turn off hydraulic 9-2350-238-10. system. Refer to TM 2-169

Privacy Statement
Press Release
Contact