MAINTENANCE OF CAB ASSEMBLY

REASSEMBLY (CONT) - TM-9-2350-238-34-2_274

REMOVAL - TM-9-2350-238-34-2_276

TM-9-2350-238-34-2 Recovery Vehicle Full-Tracked: Light Armored M578 (2350-00-439-6242) Manual
Page Navigation
266

I TM 9-2350-238-34-2 2-50. MAINTENANCE OF CAB ASSEMBLY. This task covers: a. Service c. Inspection/Repair b. Removal d. Installation INITIAL SETUP Tools and Special Tools Alinement pin (3) (fig. 1, appx C) General mechanic’s tool kit, automotive (SC 5180-90-CL-N26) Hoist, 30,000 lb (13,620 kg) minimum lifting capacity Sling, chain, 30,000 lb (13,620 kg) minimum lifting capacity Wood blocks, 12-in. x 12-in. (30.48 cm x 30.48 cm) (8) Materials/Parts Kit (5703765) Lockwasher (MS35338-46) Lockwasher (8) (MS35338-47) Lockwasher (2) (MS35338-48) Lockwasher (28) (MS35338-53) Preformed packing (2) (MS28775-222) Personnel Required 5 References TM 9-2350-238-24P-2 Equipment Conditions Boom removed from cab assembly (TM 9-2350-238-20-2) Hydraulic reservoir drained (TM 9-2350-238- 20-2) General Safety Instructions l l Use hoist and chain slings of 30,000 lb (13,620 kg) minimum lifting ca- pacity to avoid injury to personnel or damage to equipment. Make sure MASTER switch is OFF be- fore repairing electrical components. Failure to observe this warning could result in injury to personnel. SERVICE When removing the cab assembly for any reason, perform a turret bearing service IAW pages 2-269 thru 2-282 if the turret bearing service has not performed within the past 18 months. REMOVAL 1 Remove screw (1) and Iockwasher (2) and lift equipment stowage accessories box (3) from cab floor to gain access to cab well. I 2-262 Change 1

Privacy Statement
Press Release
Contact