TM 9-2350-256-10
WARNING
When breaking track, stand clear to prevent injury to personnel.
NOTE
Disconnect track between idler wheel and first roadwheel.
(2)
Remove bolt (1) and wedge (2) from outside end connector (3). When loosening bolt, tap head of
bolt with hammer to loosen wedge.
NOTE
Perform step (3) for manual pullers and step (4) for hydraulic pullers.
(3)
Tighten end connector puller (4) screws against end of track link pins (5). Strike heads of end
connector screws sharply with hammer to help loosen end connector (3) from track link pins. Take up
slack by tightening end connector puller screws. Tighten end connector puller screws equally so end
connector moves squarely off track link pins. Stop using hammer when just tightening screws moves
end connector. Stop when end connector has moved 1 in. (25 mm) from track.
NOTE
Repeat steps (2) and (3) for inside end connector using a manual puller.
3-23
