TM 9-2350-256-10
(5)
Install outside end connector (8) and tap it on.
(6)
Install wedge (9) and bolt (10) to outside end connector (8).
(7)
Repeat steps (5) and (6) for inside end connector.
(8)
If necessary, repeat procedure to replace additional track shoes.
(9)
As soon as possible, notify unit maintenance to torque disturbed end connector bolts to 140-160
pound-feet (lb-ft) (190-217 Newton- meters [Nm]) and center guide to 300-320 lb-ft (406-430 Nm),
and again after 50 miles (80 kilometers [km]).
e.
Track Removal.
NOTE
If both tracks are to be removed, do one at a time.
(1)
Disconnect track (see para. 3-6c).
(2)
Remove screws (1) and washers (2) from rear fender section so it can swing up if track hits it.
(3)
Start engine (see para. 2-10) and hold brakes. Shift transmission to reverse (R).
3-27
