TM 9-2350-256-10
3-6. SUSPENSION AND TRACK-Continued.
(5)
If applicable, disconnect two end connectors (3) and remove old track from new track (1).
(6)
Secure rope (Appx. B, item 65) to center of pin in rear track link assembly (5). Pass rope over center
guide groove (6) of sprocket hub (7), around rear support roller (8), and back around sprocket hub.
Take two turns with rope around sprocket hub and pull free end of rope taut.
(7)
Start engine and allow to idle. Place transmission shift lever in 1st and release brakes.
(8)
Hold free end of rope taut and walk in front of and to side of drive sprocket. This setup forms a power
pulley system which pulls rear end of track onto drive sprocket (9).
3-30
