TM 9-2350-256-20-1
0044 00
CORRECTIVE ACTION Continued
8.
Reconnect bulkhead to engine wiring harness and starter relay wiring harness to bulkhead disconnect.
Disconnect wire 486 from connector near bulkhead disconnect. Place red lead of multimeter in female
connector and black lead to ground. Turn MASTER switch on, push START and manifold preheat
switches, and check for voltage. Turn MASTER switch OFF. If voltage is present, go to step 9. If
voltage is not present, repair/replace wire 486 of bulkhead to engine wiring harness and starter relay
wiring harness from female connector to bulkhead disconnect (see WP 0221 00).
Remove engine deck (see WP 0336 00). Reconnect wire 486 at connector near bulkhead disconnect.
9.
Disconnect bulkhead to engine bracket and rear fuel tank transmitter wiring harness from engine
disconnect. Place red lead of multimeter in socket A of wire 486 and black lead to ground. Turn
MASTER switch ON, push START and manifold preheat switches, and check for voltage. Turn
MASTER, START and manifold preheat switches OFF. If voltage is present, go to step 10. If voltage is
not present repair/replace wire 486 of bulkhead to engine bracket and rear fuel tank transmitter wiring
harness (see WP 0222 00 for dual voltage; 0223 00 for single voltage).
0044 00-7
