TM 9-2350-256-20-1
0045 00
CORRECTIVE ACTION Continued
7.
Reconnect bulkhead to engine bracket and rear fuel tank transmitter wiring harness to engine discon-
nect. Disconnect wire 54 of bulkhead to engine wiring harness and starter relay wiring harness from
bulkhead to engine bracket and rear fuel tank transmitter wiring harness. Place red lead of multimeter
on male connector of wire 54 and black lead to ground. Turn MASTER and ENGINE FUEL SHUTOFF
switches on and check for voltage. Turn MASTER and ENGINE FUEL SHUTOFF switches OFF. If
voltage is present, repair/replace wire 54 of bulkhead to engine bracket and rear fuel tank transmitter
wiring harness (see WP 0222 00 for dual voltage; 0223 00 for single voltage). If voltage is not present,
repair/replace wire 54 of bulkhead to engine wiring harness and starter relay wiring harness (see WP
0221 00).
Reconnect switch panel to neutral safety to bulkhead wiring harness to main switch panel. Disconnect
8.
wire 54 from ENGINE FUEL SHUTOFF switch side of circuit breaker. Place red lead of multimeter on
terminal of circuit breaker and black lead to ground. Turn MASTER switch on, and check for voltage.
Turn MASTER switch OFF. If voltage is present, go to step 10. If voltage is not present, go to step 9.
0045 00-6
