TM 9-2350-256-20-1
0050 00
CORRECTIVE ACTION Continued
4.
Disconnect gage panel to bulkhead wiring harness from gage panel. Check wire 36 in gage panel
harness for continuity by placing red lead of multimeter on wire 36 and black lead on pin D. If
continuity is present, go to step 5. If continuity is not present, repair/replace wire 36 of gage panel
wiring harness (see WP 0193 00).
5.
Reconnect wire 36 to engine oil pressure gage and gage panel to bulkhead wiring harness to gage panel.
Install ground strap (5), two lockwashers (4), two screws (3), gage panel (6), three lockwashers (2),
and three screws (1) to mounting brackets. Open air inlet doors (TM 9-2350-256-10). Disconnect
bulkhead to engine bracket and rear fuel tank wiring harness from bulkhead disconnect. Place red lead
of multimeter in socket L of wire 36 and black lead to ground. Turn MASTER switch on and check
for voltage. Turn MASTER switch OFF. If voltage is present, go to step 6. If voltage is not present,
repair/replace wire 36 of gage panel to bulkhead wiring harness (see WP 0194 00 for dual voltage;
0195 00 for single voltage).
0050 00-5
