TM 9-2350-256-20-1
0050 00
CORRECTIVE ACTION Continued
6.
Reconnect bulkhead to engine bracket and rear fuel tank wiring harness to bulkhead. Remove engine
deck (see WP 0336 00). Disconnect bulkhead to engine bracket and rear fuel tank wiring harness to
engine disconnect. Place red lead of multimeter in socket F of wire 36 and black lead to ground. Turn
MASTER switch on and check for voltage. Turn MASTER switch OFF. If voltage is present, go to
step 7. If voltage is not present, repair/replace wire 36 of bulkhead to engine bracket and rear fuel tank
transmitter wiring harness (see WP 0222 00 for dual voltage; 0223 00 for single voltage).
7.
Reconnect bulkhead to engine bracket and rear fuel tank transmitter wiring harness to engine discon-
nect. Remove powerplant (see WP 0098 00). Disconnect wire 36 from engine oil pressure sending unit.
Place red lead of multimeter in wire 36 and black lead to ground. Turn MASTER switch on and check
for voltage. Turn MASTER switch OFF. If voltage is present, replace engine oil pressure sending unit
(see WP 0171 00). If voltage is not present, repair/replace wire 36 of engine wiring harness (see WP
0207 00 for dual voltage; 0208 00 for single voltage).
END OF WORK PACKAGE
0050 00-6
