TM 9-2350-256-20-1
0065 00
CORRECTIVE ACTION Continued
2.
Reconnect connector to master warning light. Disconnect gage panel to bulkhead wiring harness
from gage panel. Place red lead of multimeter in socket K of wire 27 and black lead to ground.
Turn MASTER switch on, and check for voltage. Turn MASTER switch OFF. If voltage is present,
repair/replace wire 27/27G of gage panel wiring harness (see WP 0193 00). If voltage is not present,
go to step 3.
3.
Install ground strap (5), two lockwashers (4), two screws (3), gage panel (6), three lockwashers (2), and
three screws (1) to mounting brackets. Remove three screws (7), three lockwashers (8), ground lead
(9), and flat washer (10), and release switch panel (11) from mounting brackets.
0065 00-4
