TM 9-2350-256-20-1
0071 00
CORRECTIVE ACTION Continued
10. Remove four screws (8) and four lockwashers (9) and release electrical accessories panel (10).
Reconnect electrical accessories panel wiring harness to electrical accessories panel. Disconnect wire
38/518 from winch light switch side of 15 A circuit breaker. Place red lead of multimeter on terminal
of 15 A circuit breaker and black lead to ground. Turn MASTER switch on and check for voltage. Turn
MASTER switch OFF. If voltage is present, repair/replace wire 38/518 of bilge pump main power
wiring harness from 15A circuit breaker to electrical accessories panel wiring harness connector (see
WP 0233 00). If voltage is not present, go to step 11.
11. Reconnect wire 38/518 to winch light switch side of 15 A circuit breaker. Disconnect wire 38/518 from
panel connector side of 15 A circuit breaker. Place red lead of multimeter in wire 38/518 and black lead
to ground. Turn MASTER switch on and check for voltage. Turn MASTER switch OFF. If voltage is
present, replace 15 A circuit breaker (see WP 0158 00). If voltage is not present, repair/replace wire 38
from pin A to 15 A circuit breaker (see WP 0158 00).
END OF WORK PACKAGE
0071 00-8
