TM 9-2350-256-20-1
0074 00
CORRECTIVE ACTION Continued
3.
Place red lead of multimeter in socket A of wire 38/59 and black lead to ground. Turn MASTER switch
on and check for voltage. Turn MASTER switch OFF. If voltage is present, go to step 4. If voltage is
not present, go to step 5.
4.
Remove four screws (1) and four lockwashers (2) and release electrical accessories panel (3). Recon-
nect electrical accessories panel wiring harness to electrical accessories panel. Disconnect wire 38/518
from winch light switch side of 15 A circuit breaker. Place red lead of multimeter on terminal of 15
A circuit breaker and black lead to ground. Turn MASTER switch on, and check for voltage. Turn
MASTER switch OFF. If voltage is present, repair/replace wire 38/518 of bilge pump main power
wiring harness from 15 A circuit breaker to electrical accessories panel wiring harness connector (see
WP 0233 00). If voltage is not present, go to step 5.
0074 00-4
