TM 9-2350-256-20-1
0076 00
CORRECTIVE ACTION Continued
5.
Reconnect wire 38/518 to panel connector side of 15 A circuit breaker. Disconnect wire 38/518 from
winch light switch side of 15 A circuit breaker. Place red lead of multimeter on terminal of 15 A circuit
breaker and black lead to ground. Turn MASTER switch on and check for voltage. Turn MASTER
switch OFF. If voltage is present, go to step 6. If voltage is not present, replace 15 A circuit breaker
(see WP 0158 00).
6.
Reconnect wire 38/518 to 15 A circuit breaker. Disconnect wire 518 from circuit breaker side of winch
light switch. Place red lead of multimeter in wire 518 and black lead to ground. Turn MASTER switch
on and check for voltage. Turn MASTER switch OFF. If voltage is present, go to step 6. If voltage is
not present, repair/replace wire 38/518 of bilge pump main power wiring harness from 15 A circuit
breaker to winch light switch (see WP 0233 00).
0076 00-5
