TM 9-2350-256-20-1
0076 00
CORRECTIVE ACTION
WARNING
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry contacts a metal surface a direct
short may result in instant heating of tools, damage to equipment, and injury or death to personnel.
1.
Disconnect wire 518 from winch light. Place red lead of multimeter on wire 518 and black lead to
ground. Turn MASTER and WINCH LT switches ON and check for voltage. Turn MASTER and
WINCH LT switches OFF. If voltage is present, replace lamp (see WP 0184 00). If voltage is not
present, go to step 2.
2.
Reconnect wire 518 to winch light. Disconnect electrical accessories panel wiring harness from
electrical accessories panel. Place a jumper wire from socket A to pin A of wire 38/59. Place red lead
of multimeter on pin G of wire 518 and black lead to ground. Turn MASTER and WINCH LT switches
ON, and check for voltage. Turn MASTER and WINCH LT switches OFF. If voltage is present,
repair/replace wire 518 of electrical accessories panel wiring harness (see WP 0196 00). If voltage is
not present, go to step 3.
0076 00-3
