TM 9-2350-256-20-1
0093 00
CORRECTIVE ACTION Continued
7.
Reconnect wire K of bulkhead to engine bracket and rear fuel tank transmitter wiring harness to 15 A
circuit breaker. Remove engine deck (see WP 0336 00). Disconnect wire K of batteries to master relay
voltage regulator and slave receptacle wiring harness at connector near engine disconnect bracket.
Place red lead of multimeter in female connector of wire K and black lead to ground. Turn MASTER
switch on and check for voltage. Turn MASTER switch OFF. If voltage is present, go to step 8. If
voltage is not present, repair/replace wire K of bulkhead to engine bracket and rear fuel tank transmitter
wiring harness from 15 A circuit breaker to connector (see WP 0222 00 for dual voltage; 0223 00 for
single voltage).
Reconnect wire K of batteries to master relay, voltage regulators, slave receptacle, and engine dis-
8.
connect wiring harness at connector. Disconnect batteries to master relay, voltage regulators, slave
receptacle, and engine disconnect wiring harness from engine disconnect bracket. Place red lead
of multimeter in socket A of wire K and black lead to ground. Turn MASTER switch on and check
for voltage. Turn MASTER switch OFF. If voltage is present, go to step 9. If voltage is not present,
repair/replace wire K of batteries to master relay, voltage regulators, slave receptacle, and engine
disconnect wiring harness (see WP 0190 00 for dual voltage; 0191 00 for single voltage).
0093 00-6