TM 9-2350-256-20-1
0093 00
CORRECTIVE ACTION
WARNING
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry contacts a metal surface a direct
short may result in instant heating of tools, damage to equipment, and injury or death to personnel.
1.
Remove powerplant and groundhop (see WP 0098 00 and 0099 00). Disconnect engine wiring harness
connector from control module. Place red lead of multimeter in socket A of wire K and black lead to
ground. Turn MASTER switch on and check for voltage. Turn MASTER switch OFF. If voltage is
present, go to step 2. If voltage is not present, go to step 5.
2.
Place red lead of multimeter in socket B and black lead to ground. If continuity is present, go to step
3. If continuity is not present, repair/replace GND wire of engine wiring harness (see WP 0207 00 for
dual voltage; 0208 00 for single voltage).
0093 00-3
