TM 9-2350-256-20-1
0118 00
Removal
1.
Remove fuel inlet hose (1) by loosening union nuts at each end and removing clamp (2) and nut (3).
2.
Remove fuel outlet hose (4) by loosening union nuts at each end and removing two clamps (5) and nut (6).
3.
Remove two nipples (7) and two elbows (8) from fuel pump (9).
4.
Remove fuel pump (9) and gasket (10) by removing four nuts (11) and four flat washers (12).
Installation
1.
Install fuel pump (9) and gasket (10) with four nuts (11) and four flat washers (12).
2.
Install two nipples (7) and two elbows (8) to fuel pump (9).
3.
Install fuel outlet hose (4) by tightening union nuts at each end and installing two clamps (5) and nut (6).
4.
Install fuel inlet hose (1) by tightening union nuts at each end and installing clamp (2) and nut (3).
Testing
1.
Check fuel/water separator filter cover bleeder valve and primary fuel filter cover bleeder valve for fuel pressure by
performing STE/ICE-R test 50 (see WP 0040 00) with pressure transducer.
NOTE
Follow-on maintenance: Install powerplant (see WP 0098 00).
END OF WORK PACKAGE
0118 00-2
