TM 9-2350-256-20-1
0129 00
4.
Disconnect fuel inlet hose (6) from fuel outlet elbow (7).
5.
Disconnect fuel drain hose (8) from fuel drain elbow (9).
6.
Disconnect two water level probes (10).
7.
Remove four screws (11), clamp (12), four lockwashers (13), and four flat washers (14). Remove fuel/water separator filter
unit (15) from mounting bracket (16).
8.
Remove tee fitting (4), fuel outlet elbow (7), and fuel drain elbow (9).
9.
Remove three screws (17), three flat washers (18), and mounting bracket (16).
Installation
1.
Install mounting bracket (16) with three flat washers (18) and three screws (17).
NOTE
The water level probe that is connected to the lead from the control unit must be installed in the upper
location of the fuel/water separator filter.
2.
Install two water level probes (10).
3.
Install fuel/water separator filter unit (15) onto mounting bracket (16) and secure with four screws (11), clamp (12), four
lockwashers (13), and four flat washers (14).
4.
If installing fuel/water filter unit (15), remove shipping plug from fuel/water separator cover and install bleeder valve (2)
in open position.
5.
Install fuel drain elbow (9) and connect fuel drain hose (8).
6.
Install tee fitting (4) and connect fuel outlet hoses (5 and 3).
7.
Install fuel outlet elbow (7) and connect fuel inlet hose (6).
8.
Close drain cock (1) and activate electric fuel pump until fuel flows from bleeder valve (2). Tighten bleeder valve.
NOTE
Follow-on maintenance: Install powerplant (see WP 0098 00).
END OF WORK PACKAGE
0129 00-3/4 blank
