TM 9-2350-256-20-1
UNIT MAINTENANCE
RECOVERY VEHICLE, FULL TRACKED: MEDIUM, M88A1
NSN 2350-00-122-6826, EIC AQA
FUEL/WATER SEPARATOR AUTOMATIC DRAIN SYSTEM AND SOLENOID VALVE REPLACEMENT
REMOVAL, INSTALLATION
INITIAL SETUP:
Tools and Special Tools
References
Tool kit, general mechanic's (item 59, WP 0490 00)
Suitable container
Materials/Parts
Equipment Condition
Lockwashers (4) (item 622, WP 0491 00)
Powerplant removed (see WP 0098 00)
Screws (6) (item 149, WP 0491 00)
Screws (4) (item 793, WP 0491 00)
Washers, flat (4) (item 842, WP 0491 00)
WARNING
Do not smoke or use open flame when working on fuel system: explosion may occur, causing severe
injury or death.
Removal
1.
Open drain cock and bleeder valve on fuel/water separator (see WP 0128 00) and drain fuel into suitable container.
2.
Disconnect two wiring harness connectors (1 and 2) from control module (3).
3.
Disconnect water level probes (4) and clamp (see WP 0128 00).
4.
Remove control module (3) with two attached water level probes (4) by removing four screws (5), four flat washers (6), and
clamp (7).
0130 00-1
