TM 9-2350-256-20-2
0312 00
NOTE
Early design models also use jacking screw (42).
11. Remove six direct vision blocks (43) by cutting lockwire (44) and removing two screws (45) on each prism lock wedge (46).
12. Remove six prism lock wedges (46).
13. Remove inside latch (47) from cupola door (4) by removing spring pin (48).
14. Remove plug (49) and latch spring (50) by removing two screws (51).
15. Loosen jamnut (52) and remove rod end connector (53).
16. Remove jamnut (52).
17. Drive out pin (54). Separate trigger rod (55) from latch (56) and remove trigger rod, washer (57), and spring (58).
0312 00-6
