TM 9-2350-256-20-2
0365 00
Assembly
1.
Install setscrew (41) and lubrication fitting (138) to each bearing unit (42).
Installation
1.
Install long right shaft (133) to two bearing units (134 and 135).
2.
Install levers (109 and 115) with retaining ring (132) at each end of long right shaft (133).
3.
Install lever (108) with retaining ring (131).
4.
Install short left shaft (128) to two bearing units (126 and 127).
5.
Install lever (113) with retaining ring (125) and lubrication fitting (124).
6.
Install two bearing units (126 and 127) each with two lockwashers (130) and two screws (129).
7.
Install two bearing units (134 and 135) each with two lockwashers (137) and two screws (136).
8.
Install nut (123) and clevis (122) to each end of rod assemblies (112 and 114).
9.
Connect rod assembly (112) to lever (113) with straight pin (117) and cotter pin (116). Install rod assembly to brake-apply-
and-slack adjuster lever (118) with grooved pin (120), lubrication fitting (121), and cotter pin (119).
10. Connect rod assembly (114) to lever (115) with straight pin (117) and cotter pin (116). Install rod assembly to brake-apply-
and-slack adjuster lever (118) with grooved pin (120), lubrication fitting (121), and cotter pin (119).
11. Install yokes (103 and 104) to levers (108 and 109) each with straight pin (111) and cotter pin (110).
12. Install plate assembly (91) to yokes (103 and 104) with two grooved pins (106), two cotter pins (105), and two lubrication
fittings (107).
0365 00-10
