TM 9-2350-256-20-2
0365 00
NOTE
Steps 4 thru 6 refer to brake control adjustment.
4.
Place shift control lever (139) in PARK (P) position.
5.
Push brake pedal (4) down as far as possible. Brake pedal should lock in down position.
6.
If brake pedal (4) does not lock in down position, loosen two nuts on linkage rod (140). Adjust linkage rod until brake pedal
will lock in down position. Tighten nuts.
CAUTION
Adjust brakes only after making certain brake linkage alignment is correct.
CAUTION
Do not adjust travel of brake-apply-and-slack adjuster lever to less than 3 in. (76.2 mm) because of
possible damage to brakes.
NOTE
Alignment of black mark (141) on brake rod and black mark (142) on brake adjustment gage indicates
that brakes are applied and in proper adjustment.
0365 00-20
