TM 9-2350-256-20-2
0365 00
NOTE
Steps 7 and 8 refer to brake adjustment.
7.
Apply brakes and check amount of brake-apply-and-slack adjuster lever (118) travel. Each lever (right or left) must travel
not less than 3 in. (76.2 mm), measured at outer hole (143) in end of lever. With brakes applied, black mark (141) on brake
rod should align with black mark (142) on brake adjustment gage.
NOTE
Adjustment may be made through access holes in bottom rear of hull.
8.
Release brakes and press in locking ring (144). Turn adjustment bolt (145) clockwise to shorten travel or counterclockwise
to lengthen travel, as required. (Shortening brake-apply- and-slack adjuster lever [118] tightens brakes.)
NOTE
Follow-on maintenance: Only install or close items necessary to gain access to area of linkage requiring
removal. Install oddment tray (see WP 0390 00); Install toolbox rack (see WP 0389 00); Install am-
munition rack (see WP 0386 00); Install air inlet grilles as necessary (see WP 0342 00); Install air inlet
doors as necessary (see WP 0341 00); Install cab subfloor plates (see WP 0286 00 thru 0308 00); Install
left-side air cleaner (see WP 0137 00); Install powerplant (see WP 0098 00).
END OF WORK PACKAGE
0365 00-21/22 blank
