TM 9-2350-256-20-2
0455 00
Removal
1.
Disconnect signal lamp wire assembly (1) from adapter assembly (2) and signal lamp (3).
2.
Remove screw (4), lockwasher (5), and signal lamp (3).
3.
Remove two screws (6), four lockwashers (7), two nuts (8), and bracket (9).
4.
Loosen quick-disconnect coupling nut (10). Pull front headlight assembly (11) up and remove (pulling up disconnects
electrical connector).
5.
Disconnect adapter assembly harness (12) in crew compartment. Remove shell (13) and flat washer (14) if required.
6.
Remove three screws (15), three lockwashers (16), cover (17), gasket (18), adapter assembly (2), and gasket (19).
Installation
1.
Install gasket (19), adapter assembly (2), gasket (18), cover (17), three lockwashers (16), and three screws (15).
2.
Install shell (13) and flat washer (14).
3.
Connect adapter assembly harness (12) in crew compartment.
4.
Place front headlight assembly (11) over mounting and push down to engage connector. Then, securely tighten quick-
disconnect coupling nut (10).
5.
Install bracket (9), two screws (6), four lockwashers (7), and two nuts (8).
6.
Install signal lamp (3), screw (4), and lockwasher (5).
7.
Connect signal lamp wire assembly (1) to adapter assembly (2) and signal lamp (3).
END OF WORK PACKAGE
0455 00-2
