TM 9-2350-256-20-2
UNIT MAINTENANCE
RECOVERY VEHICLE, FULL TRACKED: MEDIUM, M88A1
NSN 2350-00-122-6826, EIC AQA
DIRECTIONAL SIGNAL CONTROL AND MOUNT ASSEMBLY REPLACEMENT
REMOVAL, INSTALLATION
INITIAL SETUP:
Tools and Special Tools
Materials/Parts
Lockwashers (3) (item 638, WP 0491 00)
Tool kit, general mechanic's (item 59, WP 0490 00)
Nuts (2) (item 763, WP 0491 00)
Screws (3) (item 563, WP 0491 00)
WARNING
Be certain MASTER switch is OFF when working on electrical system to avoid electrical shock and
burns.
Removal
1.
Disconnect and remove wiring harness (1), clamp (2), screw (3), and lockwasher (4).
2.
Loosen clamp (5) and remove directional signal control (6).
3.
Remove two screws (7), clamp (8), mount assembly (9), two lockwashers (10), and two nuts (11).
Installation
1.
Install mount assembly (9), clamp (8), two screws (7), two lockwashers (10), and two nuts (11).
2.
Connect directional signal control (6) to mount assembly (9) and tighten clamp (5).
3.
Install clamp (2), lockwasher (4), and screw (3). Install wiring harness (1) and connect to directional signal control (6).
END OF WORK PACKAGE
0453 00-1/2 blank
