TM 9-2350-256-20-2
0450 00
Disassembly
NOTE
Clean and dry all parts, paying particular attention to electrical contacts.
1.
Remove door light assembly (24) by loosening six (captive) screws (25).
2.
Remove gasket (26).
3.
Remove four lamps (27) by pressing in and turning counterclockwise.
Assembly
1.
Install four lamps (27) by pressing in and turning clockwise.
2.
Install gasket (26).
3.
Install door light assembly (24) by tightening six (captive) screws (25).
Installation
1.
Install two clips (17), two screws (21), two lockwashers (22), and two nuts (23).
2.
Install electrical cable (15), screw (18), lockwasher (19), and nut (20).
3.
Install two electrical cables (15 and 16) through clips (17).
4.
Install grommet (11) over four electrical cables (4) and insert cables and grommet into hole in cover (3). Connect electrical
cables.
5.
Install taillight (12), two grommets (10), two bushings (9), two flat washers (8), two ground leads (7), two lockwashers (6),
and two screws (5).
6.
Install two lockwashers (14), two ground leads (7), and two nuts (13).
7.
Install cover (3), two lockwashers (2), and two screws (1).
END OF WORK PACKAGE
0450 00-3/4 blank
