CHAPTER 9: MAINTENANCE OF HULL- AND CAB-RELATED COMPONENTS
TM 9-2350-256-20
9-67 REPLACE/SERVICE MECHANIC'S AND DRIVER'S SEAT ASSEMBLIES-Continued
WARNING
Springs (31) are installed under compression and should be handled carefully.
9
Insert two guides (36) into two springs (31) and into support assembly (33).
10 Secure two springs (31) in support assembly (33) by installing retaining strap (30) and two retainers (32)
with four screws (34) and four new lockwashers (35).
11 Insert hollow threaded rod (26) into each of two spacers (28), one in adjuster assembly (27) and one in
retainer assembly (2).
12 Place springs (29 and 22) over rods (26) and spacers (28) and install as shown.
NOTE
When installing retainer assembly (2), be sure spring (22) ends of upper set are
behind edge of support assembly (23) and in contact with seat pan (17).
13 Install retainer assembly (2) on support assembly (23) with four screws (24) and four new lockwashers (25).
9-132